| |
| Articles |
Tutorials
| Building a Double Slip Switch, by John King |
| Read | Write comments: 12 |
Posted Thu Feb 07 2002 11:37am |
Page:
1
2
3
4
5
6
7
8
|
Step 7 - Placing the levers
To place the levers in their appropriate positions, simply place your cursor over the center of a junction spline and click the (LMB). The junctions are automatically numbered and you can even change these to names of your choice.
Two levers have been added using the procedure above. Notice that the lever for junction 100 is inside the junction, whilst the lever for Junction 101 is outside. (Preferred) (Fig.12)
fig.12
To move the lever to the outside, just press (R) and click on the spline. Here junction 100 has been successfully moved to the correct position. (Fig.13)
fig.13
|
|
|
|
